Performing A Job; Setting Up The System - Formax 6900 Series Operator's Manual

6. 6. 6. 6.

PERFORMING A JOB

PERFORMING A JOB
PERFORMING A JOB PERFORMING A JOB
6.1 6.1 6.1 6.1

Setting up the system

Setting up the system Setting up the system Setting up the system
Switch on the inserter IN-3 and, if part of the system, the AS-1A and PS-3 etc.
Refer to the operator manuals of the used modules.
Inserter IN-3 Inserter IN-3
Inserter IN-3 Inserter IN-3
Action Action
Action Action
• Check the waterlevel, refill if necessary
• If required, enter pincode to gain access to the main menu
• Select the required job
To recognize the correct job number, all jobs should have been given names. If so, the name is visible in the
framework under JOB X.
• Press the Job info key. Use the job info facility as a guide to put the envelopes at the correct enve-
lope hoppers and the documents at the correct feed stations.
• After the correct job has been selected press the OK key to confirm. Now the job information will
be sent to all modules.
• Set the envelope hopper side guides and separation
• Enter the test menu, press the 1x envelope key to bring an envelope onto the insert table.
• Check the envelope stop position, adjust if necessary.
• Set the envelope fingers
• If necessary, enter the counters menu to change or reset the counters.
• If necessary, enter the settings menu to check the thickness detector settings.
Refer to.. Refer to..
Refer to.. Refer to..
Refer to section 5.1 Preparations inserter module on page 6
Refer to section 5.3 Entering the personal pin code on page 7
Refer to section 5.4.3 Selecting a job on page 11
Refer to section 5.4.1 Job info screen overview on page 8
Refer to section 5.4.3 Selecting a job on page 11
Refer to section 5.7 Envelope hopper adjustment on page 17
Refer to section 5.4.4 Test run menu on page 11
Refer to section 5.4.5 Counters menu on page 14
Refer to section 5.4.6 Settings menu on page 14
1-800-543-5454
www.officezone.com
19/40 19/40 19/40 19/40