Power States; Powering Off The Server; Powering Off The Server Using The Ilo Mp; Table 3-1 Power States - HP Integrity rx2620 User's & Service Manual

Powering Off and Powering On the Server

Power States

Power States
The server has three power states:
• Standby power
• Full power
• Off
Plug the power cord into the appropriate receptacle on the rear of the chassis to achieve the standby power
state; the front panel power button is not turned on. Full power occurs when the power cord is plugged into
the appropriate receptacle, and either the power is activated through the iLO MP PC command, or the power
button is activated. In the off state, the power cords are not plugged in. Table 3-1 lists the server power states.
Table 3-1 Power States
Power Cable
Power States Plugged Into
Receptacle?
Standby power Yes
Full power Yes
Off No
NOTE If the power restore feature is set to Always On through the iLO MP PR command, the server
may automatically power on to the full power state.

Powering Off the Server

Power off the server using the following methods if the server is in either the standby or full power state:
• iLO MP PC command
• Power button

Powering Off the Server Using the iLO MP

To power off the server through the MP, follow these steps:
Step 1. Gracefully shut down the operating system. See Appendix B, "Booting the Operating System," on
page 147, or your operating system documentation for more information.
Step 2. Initiate a console session, and access the iLO MP Main Menu.
Step 3. Enter CM to enable command mode.
42
Power Activated through the
iLO MP PC Command; or
Front Panel Power Button
Activated?
No
Yes
No
AC Voltage DC Voltage
Applied Applied
Yes No
Yes Yes
No No
Chapter 3