Table 5-3. Power And System Led States - HP Integrity rx2620 User's & Service Manual

Troubleshooting
Identifying and Diagnosing Hardware Problems
NOTE
Systems without a Management Processor
The server LED states operate the same with servers having the optional iLO MP. See Table 5-3 for more
information.
Table 5-3 Power and System LED States
Power LED
Off
On (green)
On (green)
On (green)
On (green)
Diagnostic LEDs
Four diagnostic LEDs are provided on the display panel of the server. Additional diagnostic LEDs are
provided on the system board and are described later in this chapter.
The diagnostic LEDs warn of impending failures or present failures and allow you to take preventive or
corrective action, such as making a server backup or replacing a component. These diagnostic LEDs are
labeled 1, 2, 3 and 4.
• If no iLO MP is installed, the boot progress is monitored by diagnostic LEDs 1 through 4. During the
boot-up the LEDs will turn on in sequence until the EFI prompt is reached.
120
More detailed information on the server logs is presented in Appendix C, "Utilities,"
on page 167.
System LED
Off
Solid green
Blinking green
Blinking yellow (1/sec.)
Blinking red (2/sec.)
State
Off
Running
Booting or running code other than
operating system (boot or diagnostic).
Attention indication
Fault indication
Chapter 5