Replacing The I/O Backplane Assembly; I/O Backplane Assembly Removed - HP Integrity rx2660 User's & Service Manual

Figure 6-25 I/O Backplane Assembly Removed
Slot 1 (top, PCIe/PCI-X board; bottom PCI-X
1
board)
Slot 2 (top, PCIe/PCI-X board; bottom PCI-X
2
board)
Slot 3 (PCI-X)
3
I/O backplane riser board (top, PCIe/PCI-X
4
board; bottom PCI-X board)

Replacing the I/O Backplane Assembly

To replace the I/O backplane assembly, follow these steps:
1. Transfer any I/O cards from the removed I/O backplane assembly to the replacement I/O
backplane assembly.
2. Align the tabs with the guide slots in the server and slide the I/O backplane assembly into
place.
3. Tighten the two captive screws. See
a. Press the black knob down while turning it clockwise until it is fully tightened.
b. While holding the black knob and pressing down, press and release the blue button to
lower the black knob to the locked position.
4. Replace the top cover. See
5. If rack mounted, slide the server completely into the rack. See
Rack" (page
6. Connect any external cables to the I/O cards in the I/O backplane assembly.
7. Reconnect the power cables and power on the server. See
the Server" (page
168 Removing and Replacing Server Components
"Replacing the Top Cover" (page
143).
78).
Guide tabs
5
Gate latches (for full-length cards)
6
Bulkhead fillers
7
Sheet metal enclosure
8
Figure 6-24.
"Powering On and Powering Off
144).
"Inserting the Server into the