Management Subsystem; Ilo 2 Mp Lan Led On The Rear Panel; Ilo 2 Mp Status Leds; Pci-X Rope To Acpi Paths - HP Integrity rx2660 User's & Service Manual

Table 5-22 I/O Card Events That May Light System Insight Display LEDs (continued)
Diagnostic
LED(s)
I/O Card
I/O Card
Table 5-23 PCI-X Rope to ACPI Paths
Physical Slot #
1 - public PCI- X @ 266 MHz
2 - public PCI- X @ 133 MHz
3 - public PCI- X @ 266 MHz
Table 5-24 PCIe/PCI-X Rope to ACPI Paths
Physical Slot #
1 - public PCI- e @ 333 MHz
2 - public PCI- e @ 333 MHz
3 - public PCI- X @ 133 MHz

Management Subsystem

iLO 2 MP LAN LED on the Rear Panel

The iLO 2 MP LAN supports two LEDs, viewable from the rear of the system:
1. iLO 2 MP LAN LED, which indicates link/activity status.
2. LAN LED, which shows the link speed. Only 10 Mb and 100 Mb speeds are currently
supported on the iLO 2 MP LAN.
Table 5-25 lists the iLO 2 MP LAN link statuses with their corresponding LED states:
Table 5-25 iLO 2 MP LAN LED States
Link Status
Activity
Link with no activity
No link
NOTE: For information on the LAN LED, see

iLO 2 MP Status LEDs

There are four iLO 2 MP status LEDs on the rear panel of the server. They are as follows:
• iLO 2 MP heartbeat
• iLO 2 MP self-test
• BMC heartbeat
• Standby power
Table 5-26 lists the state of the iLO 2 MP status LEDs during normal operation.
Sample IPMI Events
Type E0h, 7346d
CC_IODISC_LBA_LINK_TRAIN_ERR
Type E0h, 7356d
IO_PCIE_LINK_SUBOPTIMAL
Physical Rope Number
12 - 15
10 - 11
4 - 7
Physical Rope Number
12 - 15
4 - 7
10 - 11
Cause
PCIe link failed to
train
PCIe link is not
running at max
capable bandwidth
Logical ACPI Path
Acpi(HWP0002,PNP0A03,700)/Pci(1|0)
Acpi(HWP0002,PNP0A03,600)/Pci(1|0)
Acpi(HWP0002,PNP0A03,300)/Pci(1|0)
Logical ACPI Path
Acpi(HPQ0002,PNP0A08,700)/Pci(0|0)
Acpi(HPQ0002,PNP0A08,300)/Pci(0|0)
Acpi(HWP0002,PNP0A03,600)/Pci(1|0)
LED State
Flashing green
Steady green
Off
"System LAN LEDs" (page
Source Notes
SFW
SFW
135).
Management Subsystem 133