Removing And Replacing The 8 Sff Drive Backplane - HP HPE ProLiant DL365 Gen10 Plus Maintenance And Service Manual

Removing and replacing the 8 SFF drive backplane

Removing and replacing the 8 SFF drive backplane
Procedure Procedure
1. Power down the server ( Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack ).
b. Remove the server from the rack (Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel ).
5. Remove all drives and drive blanks.
Note where each drive is located.
6. If installed, remove the Smart Storage Battery ( Removing and replacing the Smart Storage Battery or Hybrid Capacitor ).
7. Disconnect and remove all cables from the drive backplane.
8. Remove the drive backplane.
To replace the component, reverse the removal procedure.
Removing and replacing the 8 SFF drive backplane 122