Installing The Sas Smart Array P400 Controller And Raid Battery; Sas Smart Array P400 Controller And Pcie Expansion Board Slots; Board Lock - HP Integrity rx2660 User's & Service Manual

Figure 3-17 SAS Smart Array P400 Controller and PCIe Expansion Board Slots
NOTE:
3. Close the board locking guides to lock the PCIe expansion board into place on the system
board.

Installing the SAS Smart Array P400 Controller and RAID Battery

To install the SAS Smart Array P400 controller and the battery into the server, follow these steps:
1. Open the blue SAS Smart Array P400 controller board lock on the rear panel of the server.
SeeFigure 3-18 (page 62)
2. Install the SAS Smart Array P400 controller into the slot on the system board as shown in
Figure 3-18 (page
3. Close the board lock over the tab on the SAS Smart Array P400 controller and snap it shut.
4. Attach the SAS cables to the SAS Smart Array P400 controller.
Figure 3-18 Board Lock
62 Installing the Server
The board and slot are keyed, so the board only fits one way into the slot.
shows the location of the board lock.
62).