Manageability Reset Button On System Board Bulkhead; Manageability Status Led; I/O Subsystem (Sas/Dvd/Hdd); Verifying Sas Disk Drive Operation - HP Integrity rx2660 User's & Service Manual

Table 5-26 iLO 2 MP Status LEDs
iLO 2 MP Status LED
iLO 2 MP heartbeat
iLO 2 MP self-test
BMC heartbeat
Standby power

Manageability Reset Button on System Board Bulkhead

The Manageability reset button, accessed from the rear of the server, allows you to reset the iLO
2 MP, it optionally also resets user-specified values to factory default values. A momentary press
causes a soft reset of the iLO 2 MP, when the button is released. A greater than four-second press
does the same, and also returns user-specified values to factory default values (hard reset).
The crucial values to be reset are as follows:
• Serial terminal baud settings
• User names and passwords

Manageability Status LED

The manageability status LED indicates the state and health of the iLO 2 MP. It is visible from
the rear of the server. The states are as follows:
Table 5-27 Manageability Status LED
LED State
Off
Steady Amber
0.5 Hz Flashing Green
1 Hz Flashing Amber

I/O Subsystem (SAS/DVD/HDD)

Verifying SAS Disk Drive Operation

Each SAS disk drive has an activity LED indicator on the front of the drive.
NOTE:
On the HP Integrity rx2660 server, only the activity LED is used. The status LED is not
monitored by the OS.
Verify that the LED shows the correct activity indication for all disk drives that you installed:
1. Turn on power to the server and display monitor.
134 Troubleshooting
LED State
Flashing green
Off: The LED is solid amber when ac power is applied. It
remains solid amber for a few seconds until the iLO 2 MP
completes its self-test; then the LED turns off
Flashing green
Solid green
Definition
iLO 2 MP is not responding
Self Test
Heartbeat
ROM Error