Appendix I: Replacing the Hard Drive
APPENDIX I: REPLACING THE HARD DRIVE
The system comes with a pre-installed 3.5" SATA hard drive. You can install up to one 1.5TB hard
drive.
NOTE: Make sure that the system is
changing the hard drive.
Removing the Hard Drive
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the two (2) short screws on the side panels of the housing and the three (3) short
screws on the rear panel. Keep these sets of screws separate.
116
OFF
and the power cable has been disconnected before