Installing The Chain Drive - Yamaha XP500 2001 Service Manual

CHAIN DRIVE

INSTALLING THE CHAIN DRIVE

1. Install:
S chain drive assembly
S swingarm
2. Tighten:
S swingarm bolt
3. Adjust:
S pivot shaft
NOTE:
S With your fingers, screw in the pivot shaft until
it touches the collar and then tighten the pivot
shaft to the tightening torque.
S Tighten the nut to the tightening torque.
S Install the shock absorber and rear wheel after
the swingarm is installed.
4. Fill:
S chain drive oil
5. Check:
S chain drive oil level
Refer to "CHECKING THE TRANSFER OIL
LEVEL" in chapter 3.
5-81
ENG
40 Nm (4.0 mSkg)