Yamaha XP500 2001 Service Manual page 56

D Fasten the starter motor lead, battery negative
lead, V-belt reset coupler, and seat lock cable to
the frame with a plastic band.
Position the band clasp on the bottom of the
frame and face the band end to the outside.
E Fasten the fuel sender lead and fuel pump lead
to the frame with a plastic clamp.
F Place the wireharness and seat lock cable in the
frame holder.
G Through the seat lock cable between
wireharness and frame.
CABLE ROUTING
H Use the clamp on the back of the frame to hold the
side stand switch lead and fan motor lead.
I Connect the wireharness (wire taped area) to the
frame side T stud.
J After connecting the main switch lead, push it
between the seat lock cable adjustment area and
the frame.
K Through the main switch lead between frame and
seat lock cable.
L After connecting the wireharness and meter lead,
use a plastic clamp to connect them to stay 1.
M Connect to the headlight sub harness (left and
right)
2-32
SPEC