Cable Routing - Yamaha XP500 2001 Service Manual

CABLE ROUTING

Headlight lead
1
Horn (H mark on the back of the horn).
2
A Attach the wireharness clamp (protector
terminal) to the T stud.
B Install the wireharness to the top of the steering
after each coupler connection.
C Route the wireharness between brake hose and
upper bracket.
D Route the throttle cables between handle under
cover and upper bracket.
E Install a wireharness guide to hold down the
wireharness.
CABLE ROUTING
F Connect the brake light switch from the handlebar
switch side wiring.
G Route the throttle cables through the hole of the
handle under cover.
H Fasten the handlebar switch lead to the handlebar
using a plastic clamp.
The fastening location is the bend area on the
bottom of the handlebar.
I Connect the headlight sub-harness to the
wireharness on top of the stay (left and right)
After making the connection, push the coupler
between the front cowling and the air filter case.
2-29
SPEC