Chain Drive Oil - Yamaha TMAX XP500 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Reset button "Oil Change"
To reset the oil change indicator
light
1. Turn the key to "ON".
2. Hold the reset button pushed for
6
two to five seconds.
3. Release the reset button, and
the oil change indicator light will
go off.
NOTE:
1 If the engine oil is changed before the
oil change indicator light comes on
(i.e. before the periodic oil change
interval has been reached), the indi-
cator light must be reset after the oil
change for the next periodic oil
change to be indicated at the correct
time. To reset the oil change indicator
light before the periodic oil change
interval has been reached, follow the
above procedure, but note that the
indicator light will come on for
1.4 seconds after releasing the reset
button, otherwise repeat the proce-
dure.
1. Chain drive oil filler cap
2. Chain drive oil drain bolt

Chain drive oil

The
changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
6-15
1
2
chain drive oil should
1. Remove panel F. (See page 6-8
for panel removal and installation
procedures.)
2. Place an oil pan under the chain
drive case to collect the used oil.
3. Remove the oil filler cap and
drain bolt to drain the oil from the
chain drive case.
EAU04253
Chain drive oil
be