Adjusting the Striking Force of the Pins
You can adjust the striking force of pins by using MPX-90 Head Manager. Pin adjustment involves striking the
pattern shown in the figure. Prepare a piece of test-use printing material (brass) or other material measuring
about 60 mm (2.3 in.) by 60 mm (2.3 in.).
Procedure
From [Start] menu, click [All Programs] (or [Programs]) → [MPX-90 Head Manager]
→ [MPX-90 Head Manager].
MPX-90 Head Manager starts.
Switch on the power to the machine.
P. 28, "Switching On the Power"
Adjustment
pattern
Click [Readjust Pins].
Follow the on-screen instructions to perform
adjustment for the pins.
Set a material using the adhesive sheet and
table.
P. 33, "Loading Material Using the Adhesive
Sheet"
Print the adjustment pattern using the
head cap.
P. 33, "Loading Material Using the Adhesive
Sheet"
If the adjustment pattern fails to be printed,
see the sections given below.
P. 101, "The printed location isn't where de-
sired," P. 101, "Striking is performed, but nothing
is printed"
When you have finished, click
The window closes.
Chapter 5 Maintenance and Adjustment
5-2 Adjusting Marking Pins
.
87