Adjusting The Striking Force Of The Pins - Roland METAZA MPX-70 User Manual

5-2 Maintenance of the Marking Pins

Adjusting the Striking Force of the Pins

You can individually adjust the striking force of each separate pin. Pin adjustment involves striking the pattern shown
in the figure. Prepare a piece of test-use printing material (brass) or other material measuring about 60 mm (2-3/8 in.)
by 60 mm(2-3/8 in.) .
Procedure
Start MPX-70 Head Manager.
p 66 "Starting MPX-70 Head Manager"
How to Determine the Adjustment Values
Type in the letter and number of the location where the value that can be read is lightest. If this is difficult to determine,
decide on an appearance (darkness) to serve as a reference, and select a location having the same appearance. For
instance, if the situation is like that shown in the figure, then enter the following values.
B0
C3
B0
C2
C2
B9
C2
C1
C5
68 Chapter 5 Maintenance and Adjustment
Adjustment pattern
Click [Readjust Pins].
Follow the on-screen instructions to perform adjustment for the
pins.
When you have finished, click [X].
The window closes.