Table of Contents
Advertisement
5-4 Adjustment of the Origin-point Location
Adjusting the Location of the Machine's Origin Point
The origin point of the machine must be the center of the scale on the table. You can check the origin-point
location by printing calibration data. Adjust the origin point if it is displaced.
Prepare a plate-shaped material larger than 20 millimeters square.
1.
Print calibration data.
Switch on the power to the machine.
P. 28, "Switching On the Power"
Mount material.
Mount the head cap. Print the adjustment pattern using the head cap.
P. 33, "Loading Material Using the Adhesive Sheet"
Set material using the adhesive sheet and table.
P. 33, "Loading Material Using the Adhesive Sheet"
Start METAZAStudio.
P. 41, "Starting METAZAStudio"
Start printing.
P. 49, "Starting Printing"
Click
.
For [Look in], select the [Samples]
folder in the [METAZAStudio] folder*.
* The folder where METAZAStudio is in-
stalled
Select [Axis.mzs]
Click [Open].
Chapter 5 Maintenance and Adjustment
91
Advertisement
Table of Contents
