Table of Contents
Advertisement
Procedure
Important!
When you make a print with a lot of lines (Island Fill, etc.) on aluminum material and the like, the uneven-
ness of the material surface is increased, and consequently the head cap becomes worn out faster. Check
the state of the head cap regularly so that it can be replaced at an appropriate timing.
P.94, "The Replacement Cycle for the Head Cap"
4-2 Tips and Tricks for Text Layout
Enter the text.
P. 47, "Step3 : Enter the Text"
Click
.
The [Properties] dialog box appears.
Click the [Fill and Contour] tab.
Select the [Fill] check box.
Select [Fill] or [Island Fill].
When you select [Island Fill], you need to en-
ter Pitch as well. Pitch is the interval between
adjacent filling lines.
Click [OK].
The text is filled.
Chapter 4 More Advanced Operations
65
Advertisement
Table of Contents
