Table of Contents
Advertisement
Loading Material Using the Adhesive Sheet
Procedure
Switch on the power
P. 28 "Switching On the Power"
Ring
Tighten
Stopper
Hold the
head.
Head
Head cap
Knob
Fit the tabs here.
Make sure that the stopper contacts
the ring and the knob is tightened as
shown in the figure.
Tighten the knob if it is loose. If you make
a print as the knob is loose, the knob may
come off due to vibration.
Attach a head cap to the tip of
head.
Mount it as lightly holding the head as
shown in the figure. The head cap is attached
correctly when its tab clicks.
Set the table.
Fit the tabs on the base of the table to the
holes of the machine.
Tabs
Chapter 3 Making Prints
3-2 Getting Ready
33
Advertisement
Table of Contents
