Table of Contents
Advertisement
3-1 Switching the Power On and Off
Switching On the Power
Procedure
Power/Movement
button
Description
When the power is ON in the state shown in the figure
an error occurs immediately after the initial operation is completed. To clear the error, take the procedure
and press the Power/Movement button. The power lamp stops blinking and lights.
Switching Off the Power
Power/Movement
button
28
Chapter 3 Making Prints
OK
Ring
Knob
Stopper
Not OK
Loosen
Tighten
Hold down the but-
ton for one second
or longer.
Make sure that the stopper contacts
OK
the ring and the knob is tightened as
shown in the figure
In the case as shown in the figure
the knob to make it into the state shown in
the figure, and then tighten the knob.
Press the Power/Movement button.
The lamp of the Power/Movement button is
turned ON, and the head moves to the left
rear. This operation is called initialization.
, there are cases where the power lamp blinks and
Hold down the Power/Movement but-
ton for one second or longer.
The light goes dark and the power is
switched off.
.
, loosen
Advertisement
Table of Contents
