Olivetti d-Copia 300 Service Manual page 71

2FD/2FF/2FG
6. Remove the two screws and then remove the
inner ejection cover.
7. Insert the job separator into the copier from
the front side and slide it to the left. Secure
the front side using a +TP-A bronze screw M3
× 05 and the rear side using a pin.
* Check to see if the branch pressure lever on
the rear side of the job separator has
lowered.
+TP-A bronze screw
M3 × 05
1-3-46
Job separator
Figure 1-3-106
Screws
Figure 1-3-105
Inner ejection
cover
Pin