Olivetti d-Copia 300 Service Manual page 74

4. Move the film out of the way to the left, and
fasten the fax board into place using four M3
× 06 chrome binding screws.
5. Connect the NCU cable to connector CN1 on
the NCU board assembly.
6. Fasten the NCU board assembly into place
from the bottom with two M3 × 06 chrome
binding screws.
7. Connect the three connectors from the NCU
board assembly to the corresponding
connectors on the fax board, as follows:
• Speaker 2-pin connector → YC7
• NCU board connector → YC3
• Battery connector → YC6
Fax board
Film
Figure 1-3-112
CN1
NCU board
assembly
Figure 1-3-113
NCU board
connector
Speaker 2-pin
connector
Battery connector
Figure 1-3-114
2FD/2FF/2FG
M3 × 06 chrome
binding screws
NCU cable
NCU board assembly
M3 × 06 chrome
binding screws
1-3-49