Install the (optional) hard disk.
5. Remove 2 screws and take off the cover.
6. Push the hard disk all the way in along the
rails, and fasten it with 2 screws.
Installing the Optional Memory DIMM
7. Remove the printing system, and insert the
optional memory DIMM firmly into either of
the memory slots. Push the DIMM firmly into
the slot so that the two hooks (one hook at
each end of the slot) snap closed.
• The board provides two DIMM slots, and can
accept up to two optional DIMMs. If installing
a single DIMM, you can use either slot.
Cover
Screws
Figure 1-3-75
Option mermory
DIMM
Hooks
Figure 1-3-76
2FD/2FF/2FG
Hard desk
Screws
Memory
slots
Hooks
1-3-35