Olivetti d-Copia 300 Service Manual page 84

7. Align the rail retainer with the groove of the
guide rail and attach the rail retainer to the
guide rail. Make sure that the plate spring of
the rail retainer fits into the groove and the
edge of the guide rail fits between the pulleys
on the reverse side of the rail retainer.
8. Orient the guide rail such that its pulley is
positioned toward the copier.
9. Secure the rail retainer to the copier using
two M4 × 10 binding screws such that the
front and the rear gaps between the floor and
the rail retainer are approximately 10 mm.
Guide rail
Figure 1-3-139
Pullery
Guide rail
Figure 1-3-140
Rail retainer
10 mm
Rail retainer
M4 × 10
binding screws
Figure 1-3-141
2FD/2FF/2FG
Rail retainer
Plate spring
Rail retainer
10 mm
1-3-59