Olivetti d-Copia 300 Service Manual page 95

2FD/2FF/2FG
If excessive downward curl (case [c] in illustration):
(1) Open the document finisher's front cover.
(2) Move the lower lever one step to the left.
Note:The lever is initially set to position "1",
and can be adjusted to five positions ("1" to
"5").
(3) Run paper through the machine.
(4) Check the downward curl on the ejected
paper.
(5) Repeat steps 2 to 4 until there is no curl.
(6) Close the finisher's front cover.
If excessive upward curl (case [d] in illustration):
(1) Loosen the four screws and remove the
finisher's upper cover.
(2) Move the upper lever one step to the right.
Note:The lever is initially set to position "1",
and can be adjusted to five positions ("1" to
"5").
(3) Run paper through the machine.
(4) Check the upward curl on the ejected paper.
(5) Repeat steps 2 to 4 until there is no curl.
(6) Reattach the finisher's upper, and tighten the
four screws.
1-3-70
Front cover
Figure 1-3-171
Screws
Figure 1-3-172
Screws
1 2 3
4
5
Upper lever
Figure 1-3-173
Lower lever
1
5
4
3 2
Upper cover
Screws
Upper cover
Screws