Olivetti d-Copia 300 Service Manual page 49

2FD/2FF/2FG
10. Connect J1 on the IPC PCB to YC15 on the
main PCB.
11. Insert the board supports into the three round
holes of the main PCB and secure the IPC
PCB.
12. Refit the shield cover and rear cover.
13. Align the rail retainer with the groove of the
guide rail and attach the rail retainer to the
guide rail. Make sure that the plate spring of
the rail retainer fits into the groove and the
edge of the guide rail fits between the pulleys
on the reverse side of the rail retainer.
1-3-24
Round
holes
Round
hole
YC15
YC4
Figure 1-3-48
Main PCB
IPC PCB
J2
Board supports
J1
Board support
Guide rail
Figure 1-3-49
Rail retainer
Plate spring