Olivetti d-Copia 300 Service Manual page 159

2FD/2FF/2FG
Maintenance
item No.
U344 Setting preheat/energy saver mode
Description
Changes the control for preheat/energy saver mode.
Purpose
According to user request, selects which has priority, the recovery time from preheat or energy saver.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select control mode. The selected item is displayed in reverse.
Display
ENERGY STAR
GEEA
Initial setting: ENERGY STAR
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
U345 Setting the value for maintenance due indication
Description
Sets when to display a message notifying that the time for maintenance is about to be reached, by setting the
number of copies that can be made before the current maintenance cycle ends.
When the difference between the number of copies of the maintenance cycle and that of the maintenance
count reaches the set value, the message is displayed.
This maintenance mode is effective for only Japanese specification.
U346 Setting the sleep mode operation
Description
If the machine is equipped with the facsimile feature, this mode sets whether or not the machine performs
finisher initialization when the machine receives a facsimile with the main switch off.
Purpose
To disable finisher initialization, change the setting value to MODE1. If MODE1 is selected, however, even if the
main switch is turned off, control in the sleep mode will be performed and the power supply PCB will not be
turned off, resulting in increase of power consumption.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select MODE0 or MODE1. The selected item is displayed in reverse.
Display
MODE0
MODE1
Initial setting: MODE0
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
U402 Adjusting margins of image printing
Adjustment
See page 1-6-13.
U403 Adjusting margins for scanning an original on the contact glass
Adjustment
See page 1-6-31.
1-4-62
Description
Control in preheat mode
The fixing control temperature is lowered by 20°C/68°F and forced
stabilization is performed 30 seconds after exiting preheat.
The fixing control temperature is lowered by 15°C/59°F and forced
stabilization is performed 30 seconds after exiting preheat.
Description
To enable finisher initialization
To disable finisher initialization