Sfi Information; Sfi Timer Programming - TechniSat DIGIT MF4-K CC User Manual

7.15.7.1 SFI Information

Use the SFI Info to obtain brief information on the marked
channel or programme. If SFI information is available, this is
indicated by a next to the appropriate programme.
> Use either the arrow keys or the function keys to
mark the desired programme.
> Press the SFI key to display the information.
You can scroll or page through lengthy information text
using the arrow keys.
> Press the Back key to return to the previous table.

7.15.7.2 SFI timer programming

The electronic programme guide SFI allows you to program-
me timer events with particular ease.
> Use the arrow keys or the function keys to mark
the desired programme.
> Press the red function key Timer to open a selection
window.
> Use the arrow keys up/down to mark the required
Timer type (see Point 7.15).
> Confirm by pressing OK. The menu Manage timer
showing the data relating to the programme selected
will be displayed, so that you can check on the cor-
rectness. If required, you can make changes in this
menu (see 7.15).
> Press the Back key to return to the previous table.
The relevant line is marked. Depending on the timer
type in use, the receiver will now be switched on at the
commencement of the selected programme. If the
receiver was switched on by means of the video recor-
der timer, this will be indicated by the message "rEc"
shown in the display.Most of the functions of the remo-
te control are disabled at this stage, to avoid acciden-
tal interruption of the recording.
In stand-by mode, an active timer is indicated by the
colon in the time display blinking, or by the LED.
Deleting a SFI timer event
> If you would like to cancel a timer event programmed
via the SFI, proceed as described above, to mark the
appropriate programme.
88