TechniSat DIGIT MF4-K CC User Manual page 91

1. Video recorder timer
When you use a video recorder timer, your digital receiver
will be switched on resp. off for the programme selected, so
that it may be recorded on an external recording devicer, e.g.
on a video recorder, in your absence. Please note that you
must programme your video recorder appropriately to record
the programme.
If the receiver was switched on by a video recorder timer,
this will be indicated by the message "rec" in the display. In
this mode, most of the functions of the remote control are
disabled, to avoid an accidental interruption of the recording.
In stand-by mode, an active timer will be indicated by a blin-
king of the colon in the time display resp. in the LED.
2. Programme change time
If your receiver is in normal operating mode,it will switch to
the programmed programme slot at the time selected. In con-
trast to the setting for a video recorder timer, the controls
remain fully functional, and the receiver will not be switched
off at the end of the programme.
7.16.1 Manual programming of timers
> Press the Menu key to display the Main Menu.
> Use the arrow keys up/down to mark the item
Manage timer.
> Confirm by pressing OK.
The sub-menu Manage timer will be displayed.
(Fig..7-23)
> Use the arrow keys up/down to select the type of
timer you wish to programme.
> Press the OK key to go to the entry window in order
to programme a new timer event. (Fig. 7-24)
To programme an event, proceed as follows:
Source
> Use the arrow keys to mark the column Source.
> Confirm by pressing OK.
> In the selection window that will now be displayed,
use the arrow keys up/down to select the desired
source (TV or Radio).
> Confirm by pressing OK.
Depending on the previous setting, either the TV or
the radio programme list will now be displayed.
91
(Fig. 7-23)
(Fig. 7-24)