Manual Scan - TechniSat DIGIT MF4-K CC User Manual

(Fig. 8-17)
> You can abort the scan by pressing the red function
key.
The scan may take more than 15 minutes. Please also note
any messages displayed on the screen.

8.4.3 Manual scan

You may choose to scan a specific frequency (see Point 9,
Technical terms) for programmes (Fig. 8-17). To do this, you
will have to enter the following data:
Channel frequency
In this line you must enter the frequency at which the desired
programmes are broadcast.
> Use the arrow keys up/down to mark the line
Channel frequency.
> Use the numeric keys to enter the desired
frequency.
Symbol rate
In this line you must enter the symbol rate at which the pro-
grammes are broadcast.
> Use the arrow keys up/down to mark the line
Symbol rate.
> In this line, use the numeric keys to enter the des-
ired symbol rate.
Modulation
Use this line to enter the modulation type used.
> Use the arrow keys up/down to mark the line
Modulation.
> Press the OK key, repeatedly if necessary, to enter
the modulation type used.
> Now press the red function key Start scan. The
scan will commence. Please note any additional mes-
sages displayed on the screen.
> If you wish to abort the scan procedure, press the red
function key again.
To search very specifically for a particular programme, you
may also use the PID scan.
> Press the green function key PID scan.
> Then use the arrow keys up/down to mark the
lines PCR PID, Audio PID and Video PID and
use the numeric keys to enter the appropriate num-
bers.
> Start the scan by pressing the red function key Start
scan.
106