Planning - B&D Easylifter Instructions Manual

Planning

Identify the type and height of your garage door.
Survey your garage area to see if any of the
conditions below apply to your installation. Additional
materials may be required. You may find it helpful to
refer back to this page and the accompanying
illustrations as you proceed with the installation of
your opener.
Depending on your requirements, there are several
installation steps which may call for materials and/or
hardware not included in the carton.
• Installation Step 1 – Look at the wall or ceiling
above the garage door. The header bracket must
be securely fastened to structural supports.
• Installation Step 5 – Do you have a finished ceiling
in your garage? If so, a support bracket and
additional fastening hardware may be required.
B&D recommends the use of safety infra-red
beam sensors on all installations of automatic
garage door openers.
• Installation Step 10:
– Depending upon garage construction, extension
brackets or wood blocks may be needed to install
the infra-red safety sensors.
Sectional Door Installation
Horizontal and vertical reinforcement is
needed for lightweight garage doors
(fibreglass steel, aluminium, door with
glass panels, etc.)
SEE PAGE 21 FOR DETAILS
Safety Reversing Sensor (IR Beam)
Header Wall
Door
Cen tre
Gap between floor and bottom of
door must not ex ceed 6mm.
– Alternate floor mounting of the safety infra-red
beam sensors will require hardware not provided.
• Do you have an access door in addition to the
garage door? If not, a B&D Emergency Access
Access Device is required (B&D Part# 59009).
SECTIONAL DOOR INSTALLATIONS
• Do you have a steel, aluminum, fiberglass or glass
panel door? If so, horizontal and vertical reinforce-
ment is required (Installation Step 11).
• The opener is normally installed at the center of
the door. If there is a torsion spring or center
bearing plate in the way of the header bracket or
door bracket area, the opener may be installed
within 300mm to the left or right of the door center.
See Installation Steps 1 and 11.
• Look at the garage door where it meets the floor. It
must close on the floor all the way across.
Otherwise, the safety reverse system may not work
properly. See Adjustment Step 3. Floor or door
should be repaired.
FINISHED CEILING
Support br acket &
fastening har dware
is required .
See page 17.
Ext ension Spring
OR
Acce ss
Tor sion Spring
Door
Header
Bracket
Saf ety
Rev ersing
Sen sor
Header
Wal l
Gar age
Door
4
Motor Unit
CLOSED POSITION
Header
Sleeve Br acket
Rail Assembly
Tro lley
Gar age
Emergenc y
Door
R e e l a s e
Spring
Rope & Handle
Str aight
Door
Arm
Curved
Door
Arm
Door
Bracket