Preparing Your Garage Door; Tools Needed - B&D Easylifter Instructions Manual

Preparing your garage door

• Disable locks. Insert wood screws or nails to keep
them unlocked.
• Remove any ropes connected to garage door.
TESTING YOUR DOOR
Before you begin, complete the following test to
make sure your door is balanced and is not sticking
or binding:
• Lift the door about halfway as shown. Release the
door. It should stay in place, supported entirely by
its springs.
• Raise and lower the door to see if there is any
binding or sticking.
If your door binds, sticks, or is out of balance, call for
professional garage door service.
SECTIONAL DOOR
Sectional Door
Stepladder
114A3231
One-Piece Door
Carpenter's
Level
Drill
13mm, 11mm, and 6mm
Sockets and Wrench
To prevent possible SERIOUS INJURY OR DEATH:
• Always call for professional B&D garage door service
if garage door binds, sticks, or is out of balance. An
unbalanced garage door might not reverse when required.
• NEVER try to loosen, move, or adjust garage door, door
springs, cables, pulleys, brackets or their hardware, all of
which are under EXTREME tension.
• Disable ALL locks and remove all ropes connected to
garage door before installing and operating garage door
opener to avoid entanglement.
• This unit should not be installed in a damp or wet space.
• The door must not extend over public byway during
operation.
• This product is provided with a power supply cord of special
design which, if damaged, must be replaced by a power
supply cord of the same type; such a power supply cord
may be obtained from you local B&D distributor and
must be fitted by a specialist.
To avoid damage to the garage door and opener, disable
locks before installing and operating the opener. Use a wood
screw or nail to hold locks in the "open" (unlocked) position.
Operation at other than 230V/50 Hz will cause opener
malfunction and damage.

Tools needed

During assembly, installation and adjustment of the
opener, instructions will call for hand tools as
illustrated.
Pencil
Tape Measure
Wire Cutters
8mm, 5mm, and
4mm Drill Bits
Pliers
Locking pliers
3
WARNING WARNING
CAUTION
WARNING
CAUTION CAUTION
Hack Saw
Claw Hammer
Screwdriver
Adjustable End Wrench