Table of Contents
Advertisement
Advertisement
Chapters
Table of Contents
Related Manuals for B&D Controll-A-Door 4
Summary of Contents for B&D Controll-A-Door 4
- Page 1 Controll-A-Door INSTRUCTIONS Controll-A-Door Controll-A-Door B&D Automatic Access Systems B&D Doors New Zealand Unit 3, 4 Alfred road 70 Allens Road Chipping Norton NSW 2170 East Tamaki Australia Auckland, New Zealand Ph: (02) 9722 9100 Ph: (09) 273 8600...
-
Page 2: In The Box
START BY READING THESE IMPORTANT SAFETY RULES These safety alert symbols mean CAUTION - a personal safety or property damage instruction. Read these instructions carefully. This garage door operator is deisgned and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the following safety rules. Failure to comply with the following instructions may result in serious personal injury or property damage. -
Page 3: Assembly
Before you Begin: Install the Trolley Insert a screwdriver into trolley ‘stop’ hole in the front end of T-rail 1. Look at the wall or ceiling above the garage door. The (1). Slide trolley (2) along rail to the “stop”. header bracket must be securley fastened to structural supports. -
Page 4: Hang The Operator
Hang the Operator - 15 Installation Section 11-20 The operator must be securely fastened to a struc- tural support on the garage. Three representative installations are shown. Yours Wear protective goggles when working overhead to may be different. Hanging brackets (1) should be angled protect your eyes from injury. -
Page 5: Adjustment Section
Program Your Operator & Remote - 21 Activation of the Lighted Door Control Button Activate the operator only when door is in full view, free of Press to open or close the door. Press again to reverse obstruction and properly adjusted. No one should enter or the door during the closing cycle or to stop the door leave garage while door is in motion. -
Page 6: Install Protector System
Force Adjustment Activation of Your Operator Do not force adjustments to compensate for a binding or Your operator can be activated by any of the following devices: • The Lighted Door Control Button. Hold the button down until sticking garage door. Excessive force will interfere with proper operation of safety reverse system or damage door starts to move. -
Page 7: Troubleshooting
Having a Problem? • Operator noise is disturbing in living quarters of home: • Operator does not operate from either door control If operational noise is a problem because of proximity of or remote: the operator to the living quarters, a Vibration Isolator Kit 1. -
Page 8: Specifications
above shall run from the date of such installation and the Buyer shall be entitled Maintenance of your Operator to free service by B&D or its Authorised Distributor to remedy any defects covered by this Warranty. The buyer will pay for any service call made by B&D Once a month: or its Authorised Distributors when in the opinion of B&D these calls are made for the purpose of adjustment which is described in the Owner’s Handbook.
Need help?
Do you have a question about the Controll-A-Door 4 and is the answer not in the manual?
Questions and answers
Hi, I'm living in NZ and trying to replace my remote for the B&D Control-A-Door 4 garage door. I've tried Bunnings and have already failed twice (both for Chamberlain remotes, reference MC100AML and 84335AMLR5). Where can I find the right replacement?
You can find a replacement remote for the B&D Control-A-Door 4 garage door in New Zealand at The Warehouse.
This answer is automatically generated