Assembly; Assemble The Rail & Attach The Chain Pulley Bracket - B&D Easylifter Instructions Manual

ASSEMBLY STEP 1
Assemble the Rail
NOTE: If your opener came with a one piece rail,
proceed to Assembly step 2, page 9.
Grease inside edges of rail brace sections. Place rail
pieces on flat surface for assembly. All four rail
sections are interchangeable. Slide rail braces onto
rail section. Connect rail by sliding rail brace onto
next rail section. Tap rail assembly on piece of wood
until rail sections are flush. Repeat with remaining
rail sections.
Install the Chain
Remove chain from carton and lay chain out on floor
(do not allow chain to twist). Push pins of master link
bar through chain link and hole in back end of trolley.
Push cap over pins and onto notches. Slide clip-on
spring over cap and onto pin notches until both pins
are securely locked in place.
Insert Chain into Rail & Assemble
Header Sleeve
Slide pulley bracket and inner trolley into back
(opener end) of rail assembly, be sure to insert pulley
bracket as shown with arrow pointing toward front
(header end) of rail. Push bracket toward front
(header end ) of rail. Insert carriage bolt through
header sleeve bracket. Loosely thread spring nut
onto carriage bolt. Insert carriage bolt of header
sleeve assembly into bold cut out in pulley bracket.
Slide header sleeve assembly on to front (header
end) of rail.
INSTALLING THE CHAIN
Back End of Trolley
Car riage Bolt
Header Sleeve
Bracket
Spring Nut
Carriage Bolt
Header Sleeve
Bracket
Pulley
Bracket
Spring
Cap
Chain Link
Master Link Bar
Front (Header End)
of Rail
8
HARDWARE SHOWN ACTUAL SIZE
Spring Trolley Nut
Carriage Bolt
RAIL ASSEMBLY
Rail Piece
Grease
Rail assembly
Piece of Wood
Back
(Opener End)
of Rail

Assembly

Pulley
Bracket
Inner
Trolley
Rail Brace
Rail
Piece