Programming; To Code A Hand-Held Remote Control; To Erase All Codes; Multi-Function Remotes - B&D Easylifter Instructions Manual

PROGRAMMING

Below are instructions for programming your opener
to operate with remote control transmitters.
To Code a Hand-held Remote
Control Transmitter
USING THE "SMART" BUTTON
1. Press and hold the button on the
hand-held remote * that you wish
to operate your garage door.
2. Press and release the "Learn"
button on the back panel of the
opener.
3. The light bulb will blink when the
code has been accepted. If light
bulb is not installed, two clicks
will be heard.
To Erase All Codes From Opener
Receiver Memory
To deactivate any unwanted remote, first erase all
codes:
Press and hold the "Learn" button on
opener until the smart indicator light
goes out (approximately 6 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.

*Multi-Function Remotes

If provided with your
garage door opener,
the large button is
factory programmed to
operate it. Additional
buttons on any multi-
function remote or
mini-remote can be programmed to operate other
garage door openers.

SPECIFICATIONS

Horsepower .................... ˜ .43
Rated Pull Force.............700N
Stand-by power rating
@ 230V...........................5.5W
Type ................................Permanent split capacitor
Speed .............................1500 rpm
Volts ................................230-240 Volts AC-50Hz Only
Current............................2.0 amperes
Gears ..............................16:1 worm gear reduction
Drive ...............................Chain with one-piece trolley on
9 1 9 1
7 5 3 7 3
5
KG KG
Length of Travel..............Adjustable to 2.29m (7-1/2 feet)
Travel Rate .....................127mm (5") per second
Lamp...............................On when door starts, off 2-1/2 minutes
Door Linkage ..................Adjustable door arm. Pull cord
Personal..........................Push button and stop. Push button
Electronic ........................Independent up and down force
Electrical .........................Motor overload protector and low
Limit Device ....................Circuit actuated by limit nut.
Limit Adjustment .............Screwdriver adjustment on side panel.
Start Circuit .....................Low voltage push button circuit.
Length (Overall)..............3.1m (122-1/2")
Headroom Required .......5cm (2")
Hanging Weight ..............14.5 kg (32 lb)
Operating Frequency......433.92MHz
Computer Codes ............8
Code Switch Code..........1
Keypad Code..................1
31
Motor
Drive Mechanism
steel T-rail.
after stop.
trolley release.
Safety
and automatic reversal in down
direction. Push button and automatic
stop in up direction.
adjustment screws.
voltage push button wiring.
Dimensions
Receiver