B&D Easylifter Instructions Manual page 23

ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Centre the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Metal Doors: Drill 4.5mm (3/16") pilot holes and
fasten the bracket with the 8 x 13mm (1/4"-
14x5/8") self-threading screws provided.
• Wood Doors: Drill 8mm (5/16") holes and use
8mm x 2" (5/16"x2") carriage bolts, lock washers
and nuts or 8 x 40mm (5/16"x1-1/2") lag screws
depending on your installation needs.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Header Wall
Finished Ceiling
25mm Support
Header
Bracket
Door
Bracket
Optional
HORIZONTAL AND VERTICAL
Placement
REINFORCEMENT IS NEEDED
of Door
LIGHTWEIGHT GARAGE DOORS
Bracket
(FIBREGLASS, ALUMINUM, STEEL,
DOORS WITH GLASS PANEL, ETC.).
(NOT PROVIDED)
Vertical
Centreline of
Garage Door
Nut 8mm
FOR
For a door with no exposed framing,
or for the optional installation, use
lag screws 8mm x 40mm (Not Provided)
to fasten door bracket.
22
HARDWARE SHOWN ACTUAL SIZE
Car riage Bolt 8mm x 65mm
Lock W asher 8mm
Sheet Metal Screw
Self-Threading
Screw
8mm x 13mm
Door
Bracket
Nut
Lock
8mm
Washer
8mm
Door
Bracket
Carriage Bolt
8mm x 65mm
(Not Provided)
Top of Door
(Inside
Garage)
Top Edge
of Door
Optional
Placement
METAL DOOR
Top of Door
(Inside
Garage)
Top Edge
of Door
Optional
Placement
WOOD DOOR