Table of Contents
Advertisement
Appendix
Terms
T
U
V
Z
CS172
Description
Timer TX
The function to specify the time to start communication.
You can save costs by specifying a transmission to start
at midnight or early in the morning during which telephone
charges are less.
Total page set
The function to place the total number of pages on each
page of the fax in quick memory transmission. It is useful
for the recipient to make sure whether all pages of the fax
have been sent or not (the total number of pages are au-
tomatically placed in memory transmission).
Transmission rates
The transmission rates of the modem in the facsimile. It
can transmit in high-speed 33,600 bps. If it is set to Over-
seas TX. The international communication. In Overseas
TX, a lower baud rate will be employed. Select this mode
if you send a fax to the location at which the communica-
tion condition is poor even if it is in your country. It trans-
mits in noise-resistant 7,200 bps or 4,800 bps.
Transmission time
The time to send a fax. The higher resolution is, the longer
it takes to transmit.
Upside down
The function to specify the appropriate binding style when
transmitting a two-sided document (i.e., when pages are
printed on both sides). The binding style you select should
allow the pages of a two-sided document to be read ap-
propriately by paging right to left or top to bottom.
V.34
The communication mode under the super G3 fax com-
munication. It may not be possible to communicate in su-
per G3 mode if the receiver or sender is connected to the
line via an extension exchange equipment.
Vertical scanning
The vertical direction when the original is scanned.
Z folded original
The function to determine the document sizes before
reading and sending the original. Some facsimiles cannot
detect the document size if it has been folded. This func-
tion is available only when reading the original with the
ADF.
14
14-11
Advertisement
Table of Contents
