AMS Neve Logic MMC User Manual page 99

System Menu
Instant Chase on add machine to group
This causes machines to immediately position themselves to the Group Master position when added to a group.
MCS Presets
Pre Roll Time
This is a timecode value that sets the amount of extra timecode that a tape is re-wound by when executing a
Locate or Cycle.
Post Roll Time
This is a timecode value that sets the amount of extra time that a tape will continue for at the end of a Cycle
before rewinding to go back to the Cycle Start time.
Rewind Limit
This is the lowest timecode (or foot-frame) position that machines will go to when rewinding before they stop
automatically.
Fast Forward Limit
This is the highest timecode (or foot-frame) position that machines will go to when fast-forwarding before they
stop automatically. This is useful when using reel-to-reel tape machines to prevent the machine from
over-running the end of the tape.
Roll Back Time
This is a timecode value that sets the amount of re-wind when a Roll Back command is sent to the transport
device(s).
Issue 4
Preferences
Page 18:13