AMS Neve Logic MMC User Manual page 78

Automation
Setting Automation Modes for Controls
The Mode button by each logicator sets the automation scope for each control (either Play, Rec, Glide, Isolate,
Etc.), and also sets snapshot and linking scope.
To set the automation mode for a control, press and hold the Mode button adjacent to that control, and select
the automation mode using the fader Play, Rec, and Glide automation buttons.
To place the entire process into an automation mode, press and hold the PROCESS key at the bottom of the
panel and set the mode using the fader automation buttons.
If there are controls in that process that already have an automation mode, then the first press will isolate all
controls, the second press will add all controls.
To place all the available controls for a path into an automation mode (including the On/Clear), hold the
Access key for that path then use the fader Play and Rec buttons to select the appropriate mode.
Issue 4
Setting Automation Modes
Page 16:9