AMS Neve Logic MMC User Manual page 43

Monitoring
When PFL solo is activated anywhere on the console then the PFL signal will take over the output for the
destination(s) it is selected to. The LED in the PFL key will illuminate solid while PFL is active and routed to the
Control Room monitor speakers.
To cancel all active solo keys press the SOLO CLEAR key on the CONTROL ROOM Panel, the integral LED in the
key will stop flashing.
This does not clear PFL from the destinations it is selected to.
Cut
The CUT key is used to mute the output from a path.
Cut is at the same point in the signal path as the fader (i.e. it is similar to moving the fader down until the signal is
cut).
Pre-fader auxiliary contributions are not affected by cut.
Issue 4
Cut
Page 8:5