I/F Timeout - Oce CS175 Phase 3 User Manual

Various settings

I/F timeout

You can set the time until a communication timeout occurs for the parallel,
USB, or network interface. (Default setting: 60 seconds)
1
On the Administrator Setting screen, touch [7 Printer Setting].
– For details on displaying the Administrator Setting screen, refer to
"To display the administrator setting screen" on page 11-29.
2
On the Printer Setting screen, touch [1 I/F Timeout].
The I/F Timeout screen appears.
3
Touch [Edit] below the setting that you are specifying.
4
Press the [C] (clear) key to erase the value, and then use the keypad to
type in the default length of time (between 10 and 1000 seconds).
– If a value outside of the allowable range is specified, the message
"Input Error" appears. Type in a value within the allowable range.
5
Touch [OK].
The time until a communication timeout occurs is set.
To cancel changes to the settings, touch [Cancel].
CS175 (Phase3)
11
11-35