Rep 5.5 Dadf Drive Assembly - Xerox Phaser 3635MFP Service Manual

REP 5.5 DADF Drive Assembly

Parts List on PL 5.40
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the DADF, PL 5.10 Item 1.
2. Remove the DADF rear cover, PL 5.10 Item 9.
3. Remove the DADF door assembly, PL 5.10 Item 3.
4. Remove the DADF lift solenoid, REP 5.2.
5. Remove the DADF transport and feed assemblies, REP 5.4.
6. Remove the DADF drive assembly, Figure 1.
3
Release the
harnesses.
2
Disconnect the scan motor.
Figure 1 Drive assembly removal
Draft 4
Phaser 3635MFP
7.
4
Remove 2 screws Marked A,
then the drive assembly.
Replacement
Ensure all ground leads are connected.
1.
1
Disconnect the
door open sensor.
4-17
Remove the registration solenoid, pickup solenoid or scan motor as required, Figure 2.
DADF scan motor
DADF registration
solenoid
Figure 2 Solenoid and motor removal
WARNING
Replacement is the reverse of the removal procedure.
DADF pickup
solenoid
Repairs and Adjustments
REP 5.5