Xerox Phaser 3635MFP Service Manual page 159

Exit roll and idlers
Figure 2 Outbin assembly removal
Replacement
1. Replacement is the reverse of the removal procedure.
Draft 4
Phaser 3635MFP
REP 28.3 Front Mid Cover
Parts List on PL 28.10
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
1 injury. Moving parts can cause injury.
Remove 6 screws.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1.
2.
3.
4.
5.
6.
7.
2 8.
Remove the outbin assembly
Replacement
towards the front of the
1.
machine.
4-43
WARNING
WARNING
CAUTION
Remove the DADF, PL 5.10 Item 1.
Remove the UI assembly, REP 2.1.
Remove the left cover, right cover and rear cover, REP 28.1.
Remove the scanner assembly, REP 14.1.
Remove the front cover assembly, PL 28.10 Item 7.
Remove the 12 screws that secure the outbin assembly, refer to REP 28.2.
Remove the 4 screws that secure the front mid cover, PL 28.10 Item 6.
Carefully lift the front of the outbin assembly, then remove the front mid cover.
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 28.2, REP 28.3