Scp 6 Final Actions - Xerox Phaser 3635MFP Service Manual

HFSI
The High Frequency Service Items are shown in Table 2. To change HFSI settings, refer to GP
16 High Frequency Service Items.
Table 2 High frequency service items
Item Component Description
Print Car- Print cartridge The total sides of copies
tridge Life and prints after the last
Page HFSI reset.
Tray 1 Pickup Tray 1 pickup All sheets fed from tray 1
Roll roll assembly after last HFSI reset.
Tray 2 Pickup Tray 2 pickup All sheets fed from tray 2
Roll roll assembly after last HFSI reset.
Bypass Bypass tray All sheets fed from the
Pickup Roll retard pad bypass tray after last
HFSI reset.
Transfer Roll Transfer roll The total sides of copies
and prints after the last
HFSI reset.
Fuser Unit Fuser assem- The total sides of copies
bly and prints after the last
HFSI reset.
Service Call Procedures
SCP 5, SCP 6

SCP 6 Final Actions

Final Actions are used to evaluate the total operation of the system and to identify the actions
required to complete the service call.
Procedure
The
Complete the following, if a fault is identified, return to SCP 4 Fault Analysis:
recommended
life for new
•
component Parts list
•
installation reference
10k impressions PL 9.10 Item 1
•
•
150k feeds PL 10.22 Item 14
•
150k feeds PL 8.17 Item 31
•
150k feeds PL 7.10 Item 27
•
100k impres- PL 9.10 Item 2
•
sions
•
•
100k impres- PL 10.10 Item 1
sions
1-6
Perform the end of call subsystem maintenance actions, SCP 5 Subsystem Maintenance.
Exercise the machine in all modes, making copies and/or prints from all trays, utilizing the
DADF and the document glass. If a fault message is displayed or some other problem is
evident, go to SCP 4 Fault Analysis.
Make a proof copy or print of a customer document.
If any of the customers selections were changed, return them to the customers preferred
settings. Refer to GP 4 System Administration Tools.
Mark off any hardware/software options and modifications installed and/or enabled on the
Tag matrix card.
At the first service and at any subsequent service where changes are made or options are
added, print the configuration report and store it with machine log book. Discard any pre-
vious versions of the configuration report.
Remove and destroy any copies of test patterns.
Complete the machine service log book.
Ensure the machine and service area are clean before leaving the customer premises.
Provide customer training if required.
Draft 4
Phaser 3635MFP