Wiper Function - Holiday Rambler Imperial 2008 Owner's Manual

To use the Cummins High Idle Feature:
With the cruise control OFF (see dash
light), press and release the RES button.
Each time the switch is pressed and
released, the idle will rise 25 RPMs,
from 500-800 RPM. To lower the idle,
press and release the SET button. Engine
idle speed will decrease in 25 RPM
increments.
With the Cruise Control ON, press and
release the RES button once. Engine
speed will increase to 1000 RPM.
Push and hold the RES button. Engine
speed will increase to 1500 RPM. Use
CANCEL or turn the cruise control
OFF to return the engine to an idle.
With the Cruise Control ON, press the
SET button once. Engine will increase
to 1200 RPM. Press and hold the SET
button, engine speed will decrease to 800
RPM. Use CANCEL or turn the cruise
control OFF to return the engine to idle.
NOTE:
The transmission will not shift into gear
if the engine RPM is at or above 900.
The display will flash "6" indicating the
engine RPM is excessive. Select "N" and
lower the engine RPM. The brake also
deactivates high idle.
NOTE:
The transmission shift schedule is
automatically adjusted when Cruise
power is on to prevent unnecessary
downshifts. Turn off Cruise power in
congested traffic and mountainous
terrain.

Wiper Function

The windshield wipers are
driven by a single motor. Any
wiper function generates a
Headlamp On signal from
the Master Controller. To
disengage automatic headlight
illumination, turn off the
ignition or activate and then
deactivate the dashboard
headlamp switch.
Marker Flashlamp:
Pressing Marker Flash lamp
causes the taillights and all
marker lights to momentarily fl ash.
OFF:
Cancels all wiper operations. Wiper
function is also cancelled when the
ignition is turned off.
HI-LO:
When the button is pressed, wipers
activate on low speed. If the button is
pressed again, the high wiper speed
setting is activated. Subsequently
pressing the HI-LO button will
alternate wiper operation between
low and high speed mode.
20 0 8 I M P E R I AL
ELECTRICAL SYSTEMS - CHASSIS — 9
Wiper Wash:
Activates the wash pump relay
while the button is pressed. If no
wiper function is selected, the low
wiper will activate for a period of
approximately three wiper cycles,
after the switch is released. If any
wiper functions are selected, the
wipers will continue to run in the
selected mode after the wash button
080507c
is released.
Wiper Variable:
Operation of the Wiper Variable
button causes the low speed wiper
function to activate for one wipe. If
the button is pressed again within
approximately 30 seconds, the low
speed wiper function activates and
O
repeats at an interval determined
F
by the time between the last
F
two operations of the button.
Additional button operations will
shorten the cycle. Activating other
wiper modes cancels the variable
mode.
Example: In light rain or misting conditions
press the button once to initially clear the
windshield. If the windshield requires a second
clearing, press the button again, setting the
timed interval between subsequent wipes
required by the current conditions. To extend the
wipe interval, press the intermittent button twice
more, or switch the wipers off and use the same
method to set the desired interval.
197