Equipment - Introduction; Entry Step; Operation - Holiday Rambler Imperial 2008 Owner's Manual

EQUIPMENT — 5

EQUIPMENT - INTRODUCTION

This section covers the basic operation and
care of equipment found in the motorhome,
most of which are provided for entertainment
and comfort. More detailed information about
specifi c equipment may be found in that
particular manufacturer's manual. Optional
equipment will also be discussed in this section
which may not apply to all motorhomes.
INFORMATION:
Detailed information with CAUTION or
WARNING instructions for the various
electronics, other than what is provided
in this section, can be found in that
specific manufacturer's manual.

ENTRY STEP

Operation

The exterior electric entry
step features retractable
steps, automatic retraction
with the ignition key in the
RUN position and a last
out feature. The bar light
indicates the circuit is active
when illuminated.
NOTE:
When dry camping it is important to
note that when the switch is illuminated,
all step circuits are active and drawing
current from the chassis battery.
118
Operating the Entry Step:
1. With the entry door open, turn the step
switch on.
2. Close the door. The step should retract
and lock in the IN position.
3. Open the door. The step should extend
and lock in the OUT position. The step
will retract when the door is closed.
4. When the switch is turned off, the step
should remain in the extended position.
Close the door and turn on the ignition
switch. The step will retract for travel.
5. With the power switch off, the step
extended, the entry door closed and
the ignition turned on, the ignition
override system will engage to
automatically retract the step.
6. Turn the ignition off and open the door.
The step will extend and lock in the
OUT position. This is the "last out"
feature. When the ignition is on the
step will always activate with door
movement, regardless of the step
switch position.
CAUTION:
High curbs can impede step operation.
Use care when parked on side streets.
060066
Located on dash
If the step fails to operate:
by entry door
Verify that the step switch is ON.
Check the main power supply for the
step: a 20 Amp fuse located at the rear run
box on the R4 circuit board.
2 00 8 I MP E R I A L
A magnetic door jam switch is used to
control step operation. Use a separate
magnet to apply a "trigger" to the door
jam switch. Rotate test magnet to align
polarity fi eld.
A 5 Amp ATO blade fuse is used to
illuminate the STEP OUT dash warning
light. The fuse is located at the front
electrical bay, labeled STP IGN.
WARNING:
If the motorhome is driven with the
step in the extended position there is the
possibility of causing major damage to
both the step and the motorhome.
CAUTION:
If the Step Out warning indicator lamp
is illuminated while the motorhome is in
motion, the entry step is either partially
or fully extended. Repair the step as
soon as possible to avoid serious damage
to the entry step or motorhome.
Lubrication:
Keeping the step clean is essential for smooth
and reliable operation. Before applying a
dry spray lubricant or graphite on the slide
mechanisms, thoroughly clean the step using
a pressure washer or a stiff nylon bristle-brush
and automotive detergent. Allow the step to
thoroughly dry.
CAUTION:
Keep fingers, clothing and other
hardware away from moving
components.