Latch Adjustments; Screen Door; Keyless Entry; Operation - Holiday Rambler Imperial 2008 Owner's Manual

EQUIPMENT — 5
The seal automatically infl ates when the
engine is running and the transmission
shift selector is placed in Drive.
The entry door seal will infl ate to
approximately 3 to 4 psi.
The pressure regulator control valve is
located behind the front cap on the curb
side of the generator.
When the transmission is placed in
neutral, the entry door seal will defl ate.
CAUTION:
If the pressure regulator should require
adjustment, do not exceed 5 psi.
Damage to the seal will occur.

Latch Adjustments

Adjusting the Entry Door Latch:
Determine which bolt needs adjustment.
Observe the latch and strike bolt
alignment while slowly closing the
entry door. DO NOT attempt to latch
if alignment is off. If the alignment is
correct, allow the latch to catch in the
fi rst (primary) position only.
The latch should move to the second
position with just slight pressure applied
to the entry door. Upper and lower
latches should be evenly timed. Press on
the entry door to see if there is further
movement of the door.
The handle should operate with little
effort to open the entry door. Excess
amounts of pressure indicate the bolts
are set too far back.
120
With an Allen Wrench, loosen
the movable strike bolt. Make all
adjustments in small increments. Tighten
the bolt fi rmly after making adjustments.
The bolts should have slight up and
down movement for vibration control in
travel.
Test the operation of the dead bolt lock
to ensure proper function.
Apply silicone to the entry door rubber
gaskets to prevent squeaking. Use a one
inch sponge paint brush, sprayed with
silicone, for easy application.
CAUTION:
When operating the entry door ensure
the dead bolt latch is fully in the unlock
position prior to closing the entry door.
Failure to do so can result in damage to
the dead bolt and/or entry door.

Screen Door

Changing the Glass in the Screen Door:
The screen slider is Lexan and can be
bowed for removal and replacement.
Replace with new Lexan and reverse the
procedure.
Adjusting the Screen Door:
Loosen the chrome bolts on the hinge
side of the screen door: Two on each of
the three hinges (six hinges total).
Slots in the steel hinge allow for in and
out movement.
2 00 8 I MP E R I A L
Adjust the screen door to fi t. The hinge
should fi t tightly to the trim of the door
when the screen door is latched and the
door is open.
Removing the Screen:
The top half of the screen door is
removable to allow clear viewing
through the entry door glass while
traveling.
Rotate the clips to remove the top half of
the screen door. Store for travel.

KEYLESS ENTRY

Operation

Locks
entry & bay
doors/arms
security
system
Activates
Panic Mode
(alarm
sounds
& lights
fl ash) when
pressed &
held for 2
seconds
Keyless Entry Key Fob
NOTE:
Key fob operation distance is within
approximately 50 ft. of the motorhome.
If the door locking mechanism is not
audible, marker lights will flash when
the doors are unlocked or locked.
Turns
battery cut-
off switch
on or off
Unlocks
entry &
bay doors/
disarms
security
system
020249c