Dryer Maintenance; Central Vacuum (Optional); Operation; Maintenance - Holiday Rambler Imperial 2008 Owner's Manual

APPLIANCES — 4

Dryer Maintenance

Clean the exterior and interior as necessary,
and clean the lint fi lter after each load.
Lint Filter:
Open the door and pull the lint fi lter
upwards.
Remove lint and replace the fi lter.
CAUTION:
DO NOT operate the dryer
without the filter in place.
Exterior:
Clean with a soft, damp cloth. DO NOT use
solvents or abrasives.
Interior:
Do not use abrasives, steel wool or stainless
steel cleaning agents to clean the dryer drum.
Discoloration from fabric softeners and water is
normal and does not affect dryer operation.
114

CENTRAL VACUUM (Optional)

Operation

Start generator or plug into
shore power.
Lift lid on wall receptacle
to start vacuum. Insert the
hose in the wall receptacle
and release lid.
Connect desired attachment
on hose and start
vacuuming.
NOTE:
Consult OEM manual for detailed
operation and maintenance.
Floor Receptacle:
Push the handle in to open the receptacle.
Sweep debris smaller than the opening into the
receptacle.
031105e

Maintenance

Vacuum has a thermal protector built into the
motor to prevent overheating. If motor will not
operate, it will automatically reset in about ½
hour. If motor brushes or bearings are worn out,
the circuit protector will trip off again after a
short period of time. If this happens, contact a
qualifi ed service representative.
2 00 8 I MP E R I A L
Changing the Bag:
To keep your vacuum at top effi ciency,
change the fi lter bag at regular intervals. To
maintain cleanability, replace fi lter bag when it
is about ¾ full.
1. Unplug the power unit from grounded
outlet.
2. Rotate the bag cover counterclockwise
and remove cover.
031264f
Wall Receptacle
3. With a fi nger on each side of the inlet,
slide the bag off the inlet tube.
4. Pull the center cardboard tab to
automatically seal the bag and prevent
dust from leaking out.
031105e
5. Remove the bag from the vacuum and
discard. DO NOT reuse.
6. Check motor fi lter in back of canister.
7. Unfold the new "OX" bag and
insert into the vacuum so the center
cardboard seal tab is toward bag cover.
The top arrow should point to the bag
cover.
8. With a fi nger on each of the cardboard
tabs, slide the bag on the inlet tube.
Counterclockwise to
unlock for removal.
Clockwise to lock.
031264