Toilet - Tecma; Programming Water Level; Tank Level Sensors - Holiday Rambler Imperial 2008 Owner's Manual

WATER SYSTEMS — 6
Maintenance - Checking for Leaks:
Back of toilet: Check water supply line
connection. Toilet tissue works well to
fi nd leaks. The tissue changes texture
when contacting moisture.
Between closet fl ange and toilet:
Confi rm that fl ange screws are snug.
DO NOT over tighten screws. If leak
continues, remove toilet and check
fl ange height. Adjust the fl ange height to
7/16" above fl oor, if necessary. Replace
fl ange seal.
Maintenance - Bowl Problems:
Poor fl ush: Flush should be obtained
within two to three seconds. If a problem
persists, adjust the water level. If
problems continue, the water pressure or
fl ow rate may be low. Remove the water
supply line and check fl ow rate. Flow
rate should be at least ten quarts (9.5
liters) per minute. Water pressure should
not be below 25 psi.
Bowl will not hold water: Check for
foreign material in the ball valve.
NOTE:
If the motorhome is in storage for six
months, spray silicone on the ball valve.
Perform this maintenance monthly
during use (silicone will evaporate
in about 30 days). DO NOT use a
petroleum-based lubricant as damage to
the seals will occur.
154

TOILET - TECMA

The Tecma is an electric macerating toilet.
Only fl ush organic material and toilet paper to
avoid damage. Ensure the house batteries are
charged and interior house power is on.
Water Saver Flush:
Press and release left button. This mode
is recommended for fl ushing liquids and
small amounts of toilet paper only.
Normal Flush:
Press and release right button. This mode
is recommended for fl ushing solids and
toilet paper.
Empty Bowl:
Press both buttons simultaneously and
release. This empties the bowl and leaves
it dry for travel.
Press either button once to add water and
return to normal use.
2 00 8 I MP E R I A L

Programming Water Level

The water level in the bowl can be
programmed. The minimum recommended
refi ll level is ½" above the bowl outfall hole
(see illustration). It may be necessary to reset
the water level after switching water sources
(from city to fresh tank or vice versa).
040466e
Setting the water level:
Press both buttons and hold.
The LED's will fl ash, indicating the
toilet is in program mode.
As water enters the bowl, release buttons
to set the level of standing water in the
bowl. The level will remain constant
after each fl ush until a different water
source is used.

Tank Level Sensors

The Tecma toilet system includes a black
tank level sensor. The water icon located in the
bottom right corner of the control panel denotes
tank level and system status.
040466c