Switches - Holiday Rambler Imperial 2008 Owner's Manual

RIGHT ARROW - Audible Turn
Indicators:
Right turn indicator circuit is active. Alarm
cancels when service brake is applied.
CRUISE ON:
Cruise control is activated.
STEP OUT:
Exterior entry step is extended.
LOW WASH:
Indicates low windshield washer fl uid.

Switches

Dash switches come either with or without
a Bar Light. The Bar Light indicates the item/
function is active. Icon lighting for both switch
types illuminate with panel lamps.
Typical switch confi guration.
Driver Console:
MIRROR HEAT:
Turns on exterior mirror heat. Mirror heaters
should be used when defogging or deicing.
Mirror heat should not be left on unless
continuous fogging conditions occur.
MIRROR ADJUST:
Fine-tunes mirror views. Use
the middle switch to select
the left or right mirror. Use
the outside directional ring
to adjust angle. Place the
switch in the center position to
prevent accidental adjustment.
NOTE:
Ignition must be in the ON or ACC
position.
DRIVER SHADE:
Operates the driver shade.
PASSENGER SHADE:
Operates the passenger shade.
VORAD SAFETY SYSTEM
ADJUST (Optional):
Adjusts following distance,
changes the menu and turns the
Vorad Safety System on and
Icon
off.
illuminates
with panel
lamps
CEILING LIGHT:
Bar light Turns the front overhead lights on and off.
Illuminates
when active
ENGINE BRAKE:
Activates the control solenoid for the engine
brake system.
BRAKE HI/LO:
HI = All six cylinders.
LO = Three cylinders.
20 0 8 I M P E R I AL
ELECTRICAL SYSTEMS - CHASSIS — 9
TAG AXLE:
Air & Optional Air/Hydraulic level:
The tag axle button is incorporated into the
air or air/hydraulic control panel. Pushing
the Tag lift button will raise or lower the
tag axle after a two minute ignition ON
080378
Mirror Adjust
delay (press the Travel Mode button to
ensure two minute delay initiates).
NOTE:
DO NOT drive the motorhome over
5 MPH with tag axle raised. The
manufacturer will not be held responsible
for any damage that may occur from
driving with the tag axle raised.
Hydraulic (Optional) Level only:
A separate switch on driver console raises
and lowers the tag axle. The bar light on the
switch is illuminated when the tag axle is up.
NOTE:
Raise the tag axle when making sharp
turns under 5 mph.
Tag Axle Switch Positions:
Tag axle is down - bar light is not
020296
illuminated.
Tag axle is up - bar light illuminates.
AIR DUMP (Hydraulic Leveling Only):
Defl ates air suspension.
Dash:
DIMMER/RHEOSTAT:
Controls dash switch backlighting
when headlight switch is on.
203