Dash Air Conditioner & Heater Controls - Holiday Rambler Imperial 2008 Owner's Manual

Center Console:
GEN ON/OFF:
The generator automatically initiates a preheat
cycle when the switch is pressed to START.
The preheat cycle is indicated by the light
on the switch rapidly fl ashing. Depending on
ambient temperature the preheat cycle may
last up to 10 seconds. For detailed operating
instructions, see Section Eight of this manual.
Passenger Console:
STEP COVER:
The sliding step-well cover is extended and
retracted at two switch locations. Another
switch is located on the driver console. Power
comes from the house batteries and requires
the battery cut-off switch to be on.
CEILING LIGHT:
Turns the front overhead lights on and off.
PASS SHADE:
Operates the passenger side power sun visor.
GRAB H/STEP W:
Turns grab handle and step well lights
on and off.
Passenger Console - Base:
STEP:
Provides power to the Entry Step.
PORCH LIGHT:
Turns the outside porch light on and off.
CEILING LIGHT:
Turns the front overhead lights on and off.
BATTERY CUT-OFF:
Turns power ON and OFF to interior 12 Volt
panel.
BAY LIGHTS:
Turn bay lights on and off.
DOOR AWNING:
Extends and retract entry door awning.
EXT TV: (Optional)
Two switches used in conjunction to extend/
retract the TV. One switch serves as an extra
safety mechanism and must be held while the
other switch is used to extend/retract the TV.
CAUTION:
Ensure the TV is fully retracted before
extending or retracting the slide out.
Damage to the TV can result.
DASH AIR CONDITIONER & HEATER
CONTROLS
Blower Speed
Temperature
Control
Control
20 0 8 I M P E R I AL
ELECTRICAL SYSTEMS - CHASSIS — 9
Dash AC and Heater Control:
Designed to provide heating, cooling and
defrost capabilities for the pilot/co-pilot area.
The system is not capable of heating or cooling
the entire motorhome.
Blower Control Switch:
Controls the four speeds of the blower motor.
This is one of the most effective ways of
controlling temperature. The Mode Control
Switch must not be in the OFF position in
order for the blower to activate.
Temperature Control Switch:
Setting the switch to the red zone
controls an electric water valve
regulating the amount of engine
coolant passing through the heating
coils in the system. Rotating to the
blue zone sets the cut-in/cut-out
temperature of the air conditioning
compressor on the engine.
Mode Control Switch:
Directs air fl ow by opening or closing
damper doors. Use the Mode Control
Switch to direct airfl ow where it is
needed to maximize comfort in the
cockpit area.
NOTE:
The air conditioning compressor is
activated when using MAX A/C, A/C,
MIX and DEFROST.
080501e
Mode Control
205